You would first of change the media type for the desired tray.
Second, you would change the media type for faxes recieved.
Third you would set everyone to print and copy from another tray thats not set to that media type and make that tray default
Last You would set the machine to use default tray
[ add comment ] | permalink |
( 2.9 / 38 )When installing Equitrac on your copier, make sure of the following.
1. Make sure to call Equitrac
(Phone: 1.877.EQUITRAC,
(1.877.378.4872),
or 1.519.885.2417 for calls outside of North America
Email: support@equitrac.com )
and find out what cable is needed, if any.
2. Call your help desk and find out what the procedures for installation are. Equitrac comes in two flavors the embedded and the connected.
Embedded requires you to install software on your copier and connect via network to Equitrac.
Connected requires a special cable that makes Equitrac operate like a coin op.
3. Your can then arrange with Equitrac or have your customer arrange with Equitrac to send them the cable.
4. The next step is to install the cable or network the copier so it can see Equitrac
5. Once you can see Equitrac and you are sure all is working fine then do a quick review training and you are done.
A Note:
The cable that you get from Equitrac comes with an adapter cable. This might lead you to make a mistake. You might inadvertently connect two different Equitrac cables together becuase of it. This can occur when you are replacing an older copier with Equitrac with a newer copier with Equitrac. If such a situation occurs... you will be unable to have a fully functional Equitrac install. To remedy this you need to completely disconnect the old Equitrac cable and remove the adapter and disconnect it from Equitrac and then connect the new Equitrac cable without the adapter. Once that is done all should be well....
[ add comment ] | permalink |
( 3.1 / 40 )[ add comment ] | permalink | related link |
( 3 / 33 )The Netbios Name is the Mac's PC Name or Host Name. You find it in the advanced functions of the network settings.
Goto System Preferences
Then Network Pane
Then Click Advanced
Then Click WINS tab
You will see NETBIOS setting there...
AN EXAMPLE TUTORIAL ON HOW TO CONFIGURE TCP/IP IN MAC OS X
[ add comment ] | permalink |
( 3 / 56 )Voice over Internet Protocol (VoIP) is a general term for a family of transmission technologies for delivery of voice communications over IP networks such as the Internet or other packet-switched networks. Other terms frequently encountered and synonymous with VoIP are IP telephony, Internet telephony, voice over broadband (VoBB), broadband telephony, and broadband phone.
Internet telephony refers to communications services — voice, facsimile, and/or voice-messaging applications — that are transported via the Internet, rather than the public switched telephone network (PSTN). The basic steps involved in originating an Internet telephone call are conversion of the analog voice signal to digital format and compression/translation of the signal into Internet protocol (IP) packets for transmission over the Internet; the process is reversed at the receiving end.
VoIP systems employ session control protocols to control the set-up and tear-down of calls as well as audio codecs which encode speech allowing transmission over an IP network as digital audio via an audio stream. Codec use is varied between different implementations of VoIP (and often a range of codecs are used); some implementations rely on narrowband and compressed speech, while others support high fidelity stereo codecs.
INTRO AND TUTORIALS
MCONNECT VOIP TROUBLESHOOTING
NETWORK INSTRUMENTS VOIP TROUBLESHOOTING GUIDE
VOICE OVER IP BASICS
VOIP MECHANIC
ZDNET VOIP TROUBLESHOOTING
[ add comment ] ( 1 view ) | permalink |
( 3 / 19 )
Calendar
